4 sided dice (two-coloured) (zip-Datei)

This is a 3D print file for a two-coloured four-sided dice with an interesting concept. The cube rolls badly on a hard surface. You should put a piece of cloth, felt or similar underneath, then the dice is very good to use. The dice and the plates are printed separately and then glued together with a drop of super glue. Printing instructions and tips: Dice - The dice must be printed with about 5% filling. More filling makes the dice heavier, which makes it roll even better. Plates - Ideally you change the filament after 0.4mm for a better contrast (I print the first layer with 0.3mm and then with 0.1mm -> so change after layer 2). This technique is described here (headline “Multicolour printing by changing the filament”). You have to rotate the dice and the labels in the slicer a little bit. Then click “lay flat”.