4 sided dice (two-coloured) — new version (zip-Datei)

This is a 3D print file for a two-coloured four-sided dice. The dice dots are easy to see and clearly tactile. They are slightly recessed to prevent the dice from tilting. Rounded edges allow the dice to roll smoothly. It works best on a soft surface such as felt, fabric, or a dice board. The dice body and the plates are printed separately and glued together with a small amount of superglue. Printing instructions and tips: Dice - The dice should be printed with approximately 5% infill. A higher infill increases the weight and improves rolling behaviour. Supports on the bottom side are recommended to ensure good adhesion of the plate. Plates - For better colour contrast, it is recommended to change the filament after 0.4 mm. One possible approach is printing the first layers at 0.3 mm and the following layers at 0.1 mm, changing the filament after the second layer. This technique is described in the section “Multicolour printing by changing the filament” (https://tactiles.eu/guideline/5-general-cura-advice/).